Description

Scull Handle Clamp: 

This item includes one scull handle clamp, complete with M5x15 hex-bolt and M5 washer.

Assembly: To install, remove the old handle clamp from the oar. If the handle bolt became cross-threaded, then the bolt must be cut off with a hack saw. Once all the old pieces and the handle are removed, then remove the bolt and washer from the new handle clamp with a 8 mm wrench. Place the handle clamp on a paint stick (some people hold it on with a loop of adhesive tape) or something similar with the bolt hole facing up and line it up with the bolt hole drilled into the shaft. Carefully hand tighten the bolt with the washer on it until the enough threads are engaged so that the handle can be inserted. Line up the handle slot with the center line of the bolt and slowly slide it in to your desired total length setting. With the 8 mm wrench tighten the bolt, but not so tight that the carbon compresses around the washer.

Please give us a call at 603.659.7575 for questions and assistance